Scroll To Top

Xtreme | Tanfoglio Grips Large Frame Full Size

(No reviews yet) Write a Review

Xtreme | Tanfoglio Grips Large Frame Full Size

Xtreme | Tanfoglio Grips Large Frame Full Size

Tanfoglio Xtreme Grips now available. Extra slim panel with a great grip surface to optimize your shooting! A back rounded panel to have a confortable feeling while holding your pistol.

Fits the Stock II and Stock III type pistols

May require some little fitting/adjustment. DOES NOT FIT ROUNDED TRIGGER GUARD FRAMES


1. Small ( usually 9X19, 9X21 and .40SW calibers ) or Large Frame ( HC gun models, .38 super and .45ACP )

2. Full size ( no magwell) or custom size ( to be fitted with magwell )

3. Colors: Black, Silver, Red & Blue

Important note for installation: The Xtreme grips have been produced to tight tolerances to ensure the fit to the frame is tight with no movement.  When installing the grip screw follow these instructions. Insert the grip and apply pressure on the grip on and upward 45 degree angle to pressure the grip into the frame. Insert the screw into the grip and line it up with the frame at a 90 degree angle before attempting to screw it in. The fit will be very snug against the grips to minimize movement. Only when the screw is going straight in and NOT on an angle slowly install the screw until it is flush with the grips. Do not attempt to install the screw if it is not at the correct 90 degree angle otherwise cross threading may occur.


Important Warning: Modification to your firearm may nullify the manufacturers warranty. This product must be installed by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.

*ITAR Regulated